M
miro
Lets start with the set up
software = "Chip-Cat2.3"
Hardware = "MasterCRD2"
Card = “Fun 8515a”
System = V**c**
Sat receiver = “Nokia 9800s”
Start the prog Chip-cat, in the start screen there are two tabs with numbers (1&2)
I then click on number 1 and then load a file called "Flash.hex", it loads itself into the top half of the screen called "Program“, the bottom half call "Data" stays empty?...I then go to click on the tab 2 (24c64) and load a file called "ext_eep" Then I press the lightning bolt button and chip-cat writes it all to the fun card.....and It don't work I must be doing something very wrong. It must be me the hard and soft part are ok as for the files I don’t know If any kind board member could help me I would be very grateful....
You can answer In German or English it's ok
software = "Chip-Cat2.3"
Hardware = "MasterCRD2"
Card = “Fun 8515a”
System = V**c**
Sat receiver = “Nokia 9800s”
Start the prog Chip-cat, in the start screen there are two tabs with numbers (1&2)
I then click on number 1 and then load a file called "Flash.hex", it loads itself into the top half of the screen called "Program“, the bottom half call "Data" stays empty?...I then go to click on the tab 2 (24c64) and load a file called "ext_eep" Then I press the lightning bolt button and chip-cat writes it all to the fun card.....and It don't work I must be doing something very wrong. It must be me the hard and soft part are ok as for the files I don’t know If any kind board member could help me I would be very grateful....
You can answer In German or English it's ok